This tools is particularly suitable for collecting WEP initialization vectors so that they can be used for cracking with aircrack-ng. Capture raw 802.11 frames from the chosen particular channel and device using airodump-ng.Choose a channel and device to capture packets from.Check the wireless access points in the vicinity.Verify that wlan0 is now in monitor mode.Notice that wlan0 is in managed mode, and it is not associated with any access points. Check the wireless interfaces available.This capture can be viewed live from Wireshark running in Monitor Mode.Connect a supported wireless access point (WAP) to your computer. In the example below, channel 1 is being monitored:

Notice above that when running ` airmon-ng start wlan0` this time, it didn't say that there were any conflicting processes.įinally, specify the channel to monitor on by using ` airodump-ng mon0 -channel `. This is done by running ` airmon-ng start wlan0` again: … and recreate it now that there aren’t any interfering processes. Kill the mon0 interface using ` airmon-ng stop mon0`.: Now that those processes have been killed, start the process over. If/when airmon-ng indicates that there are interfering processes, find the processes and kill them by typing ` kill `: When running this command, a message may appear that indicates processes that “could cause trouble”: If monitoring another interface, replace 'wlan0' with the desired interface name. In order to set an interface to Monitor Mode (usually wlan0), run ` airmon-ng start wlan0`. Find out which wireless interfaces are available by running the `iwconfig` command in a terminal:

Packet capture tool aircrack